FocusHigh-precision gear, sprocket, chain, timing belt, etc.
Design, manufacturing, and processing customization of transmission parts
Design, manufacturing, and processing customization of transmission parts
mailbox
mailbox
| Installation requirements and precautions for sprocket |
Sprocket installation requirements ①根据规格正确选用传动链轮型号。 ②Check whether the position where the drive sprocket is installed (transmission output countershaft, wheel hub, etc.) is in good condition, otherwise the relevant parts must be overhauled or replaced. ③Install the main and driven sprockets in place according to the correct method, and tighten the fasteners to meet the specified torque requirements. ④After installing the drive chain and adjusting the tightness, check whether the chain and the sprocket are smoothly matched, coplanar, and there is no interference with the chain cover. Things to note ①The driven sprocket should have anti-loosening measures. ②After loading the driven sprocket, adjust the rear wheel axle with the adjuster and the rear cradle (also called the rear wheel fork) markings, so as to prevent the rear wheel from deviating, but also to avoid the early stages of the sprocket and chain. Wear. ③It is best to replace the sprocket and the chain at the same time. If only one of them is replaced, the wear of both sides will be aggravated. ④Due to the high speed of the driving sprocket and the small number of teeth, it wears faster than the driven sprocket under the same conditions, which is a normal situation. ⑤ The drive chain and drive sprocket should be cleaned and lubricated regularly to improve their service life. |
phone:0510-83886866
Mobile phone:13806688913 Jack
fax:0510-83886866
Address:Qixing Road, Yuqi Supporting Area, Huishan Economic Development Zone, Wuxi
Website:china-sprocket.net
mailbox:[email protected]
Sitemap
