one. The energy unit is of S3 duty, which might only be worked intermittently,i.e. 1minute on and 9 minutes off.
2. Clean the many hydraulic components concerned before set up of the energy unit.
three. Viscosity of your hydraulic oil shoud be 15~46 cst, which must also be clean and cost-free of impurities, N46 hydraulic oil is encouraged .
4. Check the oil level while in the tank right after the initial operation with the power unit.
5. Oil shifting is required soon after the preliminary one hundred operation hrs, afterwards when every single 3000 hrs.
Power UNITS FOR DOCK LEVELER four
This electrical power unit is deigned for those dock levellers which require floating ramps with an emergency quit function. The ramp will rise once the pump is running.The lip will expend automatically when the ramp cylinder finishes its stroke. The ramp cylinder will retract when the pump stops working. An emergency halt will likely be realized while the solenoid valve is energized. The lowering pace of each the ramp as well as the lip is adjusted by the needle valves during the procedure.
Power UNITS FOR DOCK LEVELER three
This Dock leveler electrical power unit merely raised the ramp when the motor is activated, when the ramp has reached full extension the sequence shifts to lengthen the lip. The ramp and lip are lowered by separate solenoid valves whilst the descent. The two the ramp and lip f of each functions are controlled by a needle valve. The needle valves are adjustable to achieve the wanted descent pace of each function. The 2nd relief valve assures the primary platform to become floating under load once the dock leveler is being used for loading and unloading the products, thus guarding the dock leveler correctly.