Fan Engine, 1/8 hp 120V 2.2 Amp 3-Speed
General Description: New fan motor, removed from unused 18” or 24” China Air flow Compressor diameter TPI fans. Designed to run an 18” or 24” enthusiast blade (blade NOT included).
This motor has a (detached) cord with grounded plug, motor capacitor and a 3-speed control switch. All of the wiring in the middle of your electric motor, capacitor and quickness control change is still installed however the cord itself is normally detached as observed in the photos. (Find “Control Notice” below for modify type.)
T (See “electric fan motor china application Notice” below for utilize in a variety of other applications.)
Sizes: The engine body is 5” diameter and 3 ½” long (excluding the shaft). The engine shaft is½” (0.500″) diameter x 2 ½” long with a collection screw clean. There are (4) threaded mounting lugs on the front of the motor, ½” lengthy x .16 dia. with washers and nuts. The studs appear to have got 4mm threads and also to become on a 117mm (4.6”)diameter circle (3 ¼” measured in one stud to the next).
Rate: The approximate motor speeds (with a enthusiast blade attached):1660, 1550 and 1370 RPM. Direction of rotation (facing the shaft end of the electrical motor) is Clockwise.
Control Take notice: Motors may come with EITHER a 3-swiftness rotating control KNOB OR a 3-speed PULL-CHAIN SWITCH (we’ve demonstrated BOTH variations in the images). These two types of switches both control the engine in the same way (but you possess a rotating knob and you have got a pull-chain). In the event that you order several motor at a time, we will do our best to supply your order with each one kind of control or the additional.
Application Note: Do NOT use this electric engine in a nonfan application. This is a totally enclosed fan electric engine and made to have constant ventilation over the motor casing for cooling. The casing isn’t vented and the electric electric motor will overheat and enter automatic thermal overload if run in a nonfan system where there isn’t strong ventilation past the motor. (Caution Note: the electric motor will restart immediately when it cools back off.) Using this electric motor for applications apart from 18 & 24″ TPI fans could also overload the engine and lead it to proceed into automated thermal overload. (Your companion blade from another producer may possess a steeper blade position.)
Origin: This electric motor is produced in China.