Power UNITS FOR LIFT TABLE

Electrical power UNITS FOR LIFT TABLE one
Basic Description
This electrical power unit is intended solely for that small lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit is widely employed from the market of logistic units including minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is managed through the solenoid valve with all the velocity managed by the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Common Description
This power unit is created solely for that medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve along with the speed controlled through the adjustable needle valve. When the lift rises to a large positoin, but the power provide is minimize, the decreasing motion is controlled through the guide override perform.
Energy UNITS FOR LIFT TABLE three
Basic Description
This electrical power unit is built exclusively for that huge lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve as well as speed managed by a strain compensated flow manage valve.
Electrical power UNITS FOR LIFT TABLE 4
Standard Description
This energy unit is designed exclusively for your large lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve and also the velocity controlled through the adjustable needle valve. When the lift rises to a high positoin, but the energy supply is lower, the reducing movement is managed through the manual override perform.
Unique Notes
1. This electrical power unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean each of the hydraulic elements concerned ahead of set up of the power unit.
3. Viscosity from the oil shoud be 15~46 cst,which ought to also be clean and free of charge of impurities.N46 hydraulic oil is encouraged.
four. Oil changing is needed just after the original 100 operation hours,afterwards as soon as every 3000 hrs.
five. The electrical power unit proven is designed to be mounted vertically.